#
# this config file will save various reports of vital system information.
-# by default, all the reports are enabled and are saved in /var/backups.
+# by default, all the reports are saved in /var/backups.
#
-# requires dpkg, sfdisk, and hwinfo
+# requires dpkg, debconf-utils, sfdisk, and hwinfo
#
-# (1) a list of all the packages installed and removed.
+# (1) a capture of the debconf package selection states. This file
+# can be used to restore the answers to debconf questions for
+# packages that you will be installing through (2) below. To
+# do this, run: "debconf-set-selections < debconfsel.txt"
+#
+# (2) a list of all the packages installed and removed.
# this file can be used to restore the state of installed packages
-# by running "dpkg --set-selections < dpkg-selections.txt
+# by running "dpkg --set-selections < dpkg-selections.txt and
+# then run "apt-get -u dselect-upgrade". If you have the
+# debconf-set-selections file from (1), you should restore those first.
#
-# (2) the partition table of all disks.
+# (3) the partition table of all disks.
# this partition table can be used to format another disk of
# the same size. this can be handy if using software raid and
# you have a disk go bad. just replace the disk and partition it
# by running "sfdisk /dev/sdb < partitions.sdb.txt"
# (MAKE SURE YOU PARTITION THE CORRECT DISK!!!)
#
-# (3) hardware information.
+# (4) hardware information.
# detailed information on most important aspects of the hardware.
#
+# (5) the Luks header of every Luks block device, if option luksheaders
+# is enabled.
+# in case you (have to) scramble such a Luks header (for some time),
+# and restore it later by running "dd if=luksheader.sda2.bin of=/dev/sda2"
+# (MAKE SURE YOU PASS THE CORRECT DEVICE AS of= !!!)
+#
+# (6) LVM metadata for every detected volume group, if "lvm = yes"
+#
# here are the defaults, commented out:
+# The output from the sys handler will be placed in $parentdir
+# parentdir = /var/backups
# packages = yes
# packagesfile = /var/backups/dpkg-selections.txt
+# selectionsfile = /var/backups/debconfsel.txt
# partitions = yes
# NOTE: the __star__ below will be replaced by the disks found on the
# hardwarefile = /var/backups/hardware.txt
# dohwinfo = yes
+# luksheaders = no
+# NOTE: the __star__ below will be replaced by the Luks partitions found on the
+# system (e.g. luksheader.sda2.bin, luksheader.sdb3.bin). If you change
+# the luksheadersfile default below, be sure to include the __star__
+# replacement in the filename, or you will get one file for only one partition,
+# the others being written to the same file, and then overwritten by the next.
+# luksheadersfile = /var/backups/luksheader.__star__.bin
+
+# lvm = no
+
+# If vservers = yes in /etc/backupninja.conf then the following variables can
+# be used:
+# vsnames = all | <vserver1> <vserver2> ... (default = all)